|
SERVICES
Since over ten years,
the Piping Engineering Division can offer, with its qualified technical
staff, a complete assistance for a plant realization, from the design to
the setting up.
OUR ACTIVITY
Piping design (stress analysis).
Piping
constructive
drawing.
Components
design.
Structures
design.
Structures
drawing.
Assistance during the
erection stages and starting of a plant.
AREA
OF PERTINENCE
Thermoelectric
power plants at combined cycle and re-powering of existing units.
Co-generation
power plants based on turbine or boilers acting with liquid or gas fuel.
Bio-mass
power plants.
Waste burning
power plants (RSU and similar) and tele-heating.
Energy transmission
and distribution systems. |
PLANNING AND
CALCULATION CODES
Our technical staff
with the support of the best software presently available can project
any type of plant.
Calculation codes:
Caesar & Pipeplus (for
checking of pipes – stress analysis)
Ludi & Tecnostel (for
checking of structures)
Straus & Ansys (for
checking of structures and finished elements – FEM)
Esapro, Tecnometal,
Inventor & Autocad (for the design and development of pipes and
structures)
STANDARDS WE REFER
TO
We
project
piping in accordance with the following norms:
ANSI B31.1; ANSI B31.3;
ASME III Subsection NC & ND, British Standard 806
We
project structures in accordance with the norms:
CNR 10011;
EC3 ; NTC2008.
QUALITY AND
CERTIFICATIONS
|
|
